Next Generation Emulation banner

1 - 10 of 10 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
ok i'm in the water temple and have gotten the longshot and i'm at the part where you raise the water halfway use hte bow and arrow to hit the eye which opens the doorway then you have to use the longhost on the target before the door closes but on my pj64 the hookshot and stuff it doesn't move up down right and left smoothly it runs in blocks and i can't get it to fit on the target right can anyone help me?
 

·
king Kong Never Dies!
Joined
·
2,057 Posts
adjust the sensitivity of the controller. I dont know about N-rage plugin, i used some other controller plugin to play zelda oot and the plugin allow me to set the sensitivity of the controller. Try pj64 official homepage, there should be a plugin that allow u to adjust the sensitivity.
 

·
IceyD the Ice Cold Prince
Joined
·
176 Posts
gamepad

yes change the sentivety of the pad in the menu should help you it did me until I got a new gamepad with a anlog stick its called saitek p2000
 

·
king Kong Never Dies!
Joined
·
2,057 Posts
Originally posted by Gogeta
tried it but it didn't seem to have any effect any other suggestions

set it to the lowest sensitivity, which is about 50 if i am not mistaken. And didnt seem to have any effect? then u must be doing something wrong or may be not even set the sensitivity ( but u think u did it) .
 

·
Registered
Joined
·
10 Posts
Discussion Starter #7
ok i got it to work right well now i'm going through it and for some reason i loaded a save state and uhuh the sound quits on me and i tried change plugins deleting and reinstalling but it doesn't change and i have been saving my plugins and saves but it still doesn't work i even didn't try putting my plugins back in but that still didn't work anyone got any ideas
 

·
king Kong Never Dies!
Joined
·
2,057 Posts
Originally posted by Gogeta
ok i got it to work right well now i'm going through it and for some reason i loaded a save state and uhuh the sound quits on me and i tried change plugins deleting and reinstalling but it doesn't change and i have been saving my plugins and saves but it still doesn't work i even didn't try putting my plugins back in but that still didn't work anyone got any ideas

This is a known bug.

Solution : save the game using the normal game save function ( that means using the memory card to save,not the save sate function ). Then quit the emulator, and start the game again by loading the saved game ( that means load the memory card ) and the sound will be back.
 

·
IceyD the Ice Cold Prince
Joined
·
176 Posts
I dont think it is a known bug because for some reason I can save state o zelda oot and I still have sound. The plugins I use are as follows:
Jabo's Direct3D6 1.30
Jabo's DirectSound 1.30
and Jabo's DirectInput7 1.30

But I dont have a solution for you because I dont even know why it works for me sorry
 

·
king Kong Never Dies!
Joined
·
2,057 Posts
Originally posted by Iceydamo
I dont think it is a known bug because for some reason I can save state o zelda oot and I still have sound. The plugins I use are as follows:
Jabo's Direct3D6 1.30
Jabo's DirectSound 1.30
and Jabo's DirectInput7 1.30

But I dont have a solution for you because I dont even know why it works for me sorry

It is a known bug.

It happnes sometimes due to some unknown reasons. U said u can save state to oot and still have sound just because u r more lucky than others.


And check pj64 board, some players has stated the problems.
 
1 - 10 of 10 Posts
Top