Next Generation Emulation banner
1 - 3 of 3 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
Well im not far into disk 2, and up until now its been smooth sailing with no problems what so ever....UNTIL i go Through the South Gate.
After i show the guard my pass and proceed through the gate, where i Should enter the over head map part...Instead i get crashed back to windows....

I tried it not using any save states but still no good.

Will i have to try find a save state after this event or is there another solution for this?

Im running ff9 from an ISO


System
------------------------------------
633mhz Celeron
256mb sdram

------------------------------------
Plugin: Pete's DX6 D3D Driver 1.1.55
Author: Pete Bernert
GFX card: Intel(r) 82810 Graphics Controller

Resolution/Color:
- 640x480 Fullscreen - [16 Bit]

Textures:
- R5G5B5A1
- Filtering: 2
- Caching: 2

Framerate:
- FPS limit: on
- Frame skipping: off
- FPS limit: 65

Compatibility:
- Offscreen drawing: 3
- Framebuffer texture: 0
- Alpha multipass: on
- Mask bit: off
- Advanced blending: hardware

Misc:
- Scanlines: off [0]
- Unfiltered FB: off
- Dithering: on
- Full vram: off
- Game fixes: on [00000200]

Also using-
Petes CDR 1.08
Petes sound

:( :( :(
 

· Registered
Joined
·
4 Posts
Discussion Starter · #8 ·
Ninja-
Hyper Shinzo, How is the onboard video working for you, other than your obvious problem with FF9?
Well It works perfectly well with ePSXe except Petes OpenGL (which it obviously doesnt support?)

Anyways im usin the 810e board (no agp slot) so my choises for upgrading are fairly limited, but im not to worried as i have yet to meet a problem with the onboard card...

And as for my FF9 problem, after trying everything possible to correct it, ive come to think that it was just a bad dump of the disk 2 ISO, as all the other disks work fine.

Also thanks ALOT for the save states, helped me alot in the troubleshooting process :)

Well im rambling now....Cya!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top