Joined
·
1 Posts
The sticks on my controller are centered, but the software shows them as UP LEFT positioned.
Also when i move the sticks to DOWN RIGHT they are perfectly in the middle in the software.
Can i change the values anywhere?
![Photograph Light Product Input device Peripheral]()
I made a short clip of the problem:
Can i configure this in any way so i can center the sticks?
Also when i move the sticks to DOWN RIGHT they are perfectly in the middle in the software.
Can i change the values anywhere?
I made a short clip of the problem:
Can i configure this in any way so i can center the sticks?
