Next Generation Emulation banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
After countless tries, I’ve finally been able to successfully load a “new game” with Chrono Cross. I’ve had to start the ePSXe (1.60) with the –noauto option, as recommended on several places on the web. So far everything is fine and good.

Problem is that I can’t use ePSXe’s savestate option when I play in “noauto”-mode, nor can I either capture screenshots. It just won’t work. Why is this?

When I load a Chrono Cross savefile from the memory card, when the emulator is “normal” mode, I can quicksave and load as much as I want, but then the game freezes when I want to use elements in battles.

The only option I have to play Chrono Cross on a emulator is to load it with the the –noauto option, and save “normally” on the memory cards. But where’s the point in emulating a game then, if I can’t have fun with it? What shall I do?
 

·
Premium Member
Joined
·
26,303 Posts
You could try using ePSXe 1.5.2
 
1 - 2 of 2 Posts
Top