Next Generation Emulation banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 · (Edited)
I have a multitap which has been modded to connect to a parallel port. I am trying to figure out how NTPads multitap support works. The controller in slot 1 works, however, none of the other slots work. Anyone have any ideas, or if there is a wiring issue that needs to be changed for the multitap to work? IE, what parallel pin should the command pin be connected to?

Power is not an issue... I think. Just have two DDR pads hooked up too it, so not like I am trying to run two dualshock controllers.

Any suggestions?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top