Next Generation Emulation banner

1 - 7 of 7 Posts

·
Registered
Joined
·
1,238 Posts
Discussion Starter #1
Hi to all of u.

For about 1 week, i ve had a lot of troubles which caused me to lower the fsb.
Well, i ve seen a board on the mobo which explained how to configure the cpu multplier w/ jumpers.
It reffered to 4 jumpers: JX1; JX2; JX3 and JX4.
I ve found the last one (which was covered initially by a jumper in order to do a 5.5x ratio.That was the only one i ve found)

So can someone know where are situated the other ones???
A picture or an explanation would be really appreciated about those weird jumpers ( i know that modifying the cpu multiplier is impossible, but i can at least give it a try...)

Thx for ur help

Bye
 

·
Super Moderator
Joined
·
6,283 Posts
Don't you have your MOBO manual? It should be written/shown where they are.
 

·
Registered
Joined
·
1,238 Posts
Discussion Starter #3
I ve already checked thank u!
If i give advices like: "Check the readme"
I m also doing the same thing.
Nothing s one this side :(

Anyone has it???
 

·
Super Moderator
Joined
·
6,283 Posts
What is the exact name of your card?
 

·
Registered
Joined
·
1,238 Posts
Discussion Starter #7
Oh, just forget it:

I ve found them. there were not jumpers anymore:
There are soldered in the proper order (like jumpers).
So i tried to solder myself those ones and what do i see while I was booting?
An error message from yhe bios:

Cpu has ben changed, reset the defaults settings.. eheh.
Well; it was worth the try anyway, I ve found those jumpers.

Bye
 
1 - 7 of 7 Posts
Top