Next Generation Emulation banner

1 - 6 of 6 Posts

·
Registered
Joined
·
416 Posts
Discussion Starter · #1 ·
hay ^^

at first everyone should know i don't know anything about webcams and this big toaster next to me <.<

my problem:
after i put out the usb cabel of my cam to print something and i pulled it back it does not work. i changed nothing else o.o.
now when i start my cam i only see a black screen or some neogreen lights when i tape the lamps.
i tested it in a cam programm and on msn (^^') both didnt work.

hm what should i add too...
the name of the cam is MS-tech (i think so o_O)

i really don't know what i can do or have to try to get more information. .___.
 

·
Registered
Joined
·
1,577 Posts
Right click "My Computer" and click "Properties". Switch to the "Hardware" tab and click on "Device Manager". Check if the camera is listed under "Imaging Devices". If not, plug it into another USB socket and try again.

Regards,
scottlc
 

·
Registered
Joined
·
416 Posts
Discussion Starter · #3 ·
Sadly, that didn't work, but thanks anyway ^_~

it looks not like a software problem, I will need to contact the shop. .__.
 

·
Premium Member
Joined
·
3,093 Posts
But is it listed? If it isn't, but your printer is, probably your printer drivers took over the usb port for the camera. In the list of usb devices, if the cam isn't listed and the printer is, double click on it, choose the 'driver' tab, and click on 'revert to previous driver'. Hope that helps. And please dress that man >_>
 

·
Registered
Joined
·
416 Posts
Discussion Starter · #5 ·
yes it was listed but as always when i start DScaler i get a message "video signal not found"

we (^^' i was there anyway...) tried that "printer-thing" (@[email protected]) already.
 

·
Premium Member
Joined
·
3,093 Posts
Dunno... reinstall the drivers? :laugh:
 
1 - 6 of 6 Posts
Top