Next Generation Emulation banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey, i posted this in the wrong area i hope this is the right one. I just got ePSXe and started playing Aromored Core. I would like to control the turning and look up/down with the movement of the mouse and control the forward, rearward and straff left/right with the numpad arrows. Is this possable? The advice i got so far was to look in the pad config. drop down box. I looked but cant figure it out..
 

·
Is this thing on?
Joined
·
2,121 Posts
Try using the below switch to activate the mouse...(Though I never exprimented with this before.)

-anamous...........................Enables Analog Pad Emulation via Mouse.

To activate this switch;
Create a shortcut to EPSXE.EXE
Right-Click the shortcut and click on Properties
Put the switch -anamous in front of the target and click OK
Run the shortcut

Hope the above provide sufficient infomation.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Doesnt work. I tried to put it in front as well as throughout the target but keep getting an error message saying the target is incorrect and it wont let me have it anywhere except at the end of the target but when i try to use the shortcut afterward it gives me a syntax error. Would a custom control pad configurator work???
 
1 - 3 of 3 Posts
Top