Next Generation Emulation banner

1 - 10 of 10 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1 (Edited)
Ok, here's the deal. When playing MDEC movies in FF9 (with the DX7, the soft works just fine) i get this weird out of sync vertical line ~ 1/3 from the right hand side of the screen. when I take a screen shot, it doesn't show up.... Any suggestions (other than switching back to the soft plugin)

Next:

when flying around on the Invincible, every once in a while this weird wireframelike thing pops up. The attached picture shows it. Again, this only occurs on the DX7, and not the soft.

Any suggestions here?

Thanks a lot!

-Cliff


EDIT: picture is down the page, I had to make a new reply
 

·
Registered
Joined
·
16 Posts
Discussion Starter #3 (Edited)
OK Here's the picture:
Sorry that it wouldn't let me insert it into my original msg. this just flickers on every now and then, and then goes away...
 

·
Super Moderator
Joined
·
6,283 Posts
Just one question:
Is your video card overclocked?
Also,can you post your plugin configuration?(a screenshot would be the best).
 

·
Registered
Joined
·
1,238 Posts
I ve one thing to say:


WTF IS THAT????????????????????????????????????????????????

Whew, sorry i got surprised.
Hum well, it s the first time i see that (pete! bad boy! what have u done! J/k ;) )

well, put ur system specs and ur plugin configuration....


Thx
 

·
Registered
Joined
·
16 Posts
Discussion Starter #6
Plugin: Pete's D3D Driver 1.1.50
Author: Pete Bernert

Resolution/Color:
- 1024x768 Fullscreen - [16 Bit]

Textures:
- R8G8A8A8
- Filtering: 0
- Caching: 2 - 41 textures usable

Framerate:
- FPS limit: on
- Frame skipping: off
- FPS limit: Auto

Compatibility:
- Offscreen drawing: 2
- Framebuffer texture: 2
- Alpha multipass: on
- Mask bit: on
- Advanced blending: hardware

Misc:
- Scanlines: off
- Unfiltered FB: off
- Dithering: on
- Full vram: off
- Game fixes: on [00000200]


700 mhz PIII
128 megs of ram
ATI Rage 128 Mobile (yes, a laptop)

And remember, it just flickers on and off every once in a while, not nearly aall the time. And other than this, nothing else is wrong. The game runs perfectly at NTSC speed.
 

·
Registered
Joined
·
1,238 Posts
well, are u using a tweaking program?
If yes put the defaults settings...

Try to do like this configuration.
 

·
Registered
Joined
·
1,238 Posts
i Forgot:

Try to put different modes of Advanced blendings( software/ hardware.)
and try to put the 32 bits color depth too (and disable the 16bits color dithering)

See ya
 

·
Registered
Joined
·
2,158 Posts
The line in MDEC's is cause by Filtering...disabling filtering of Mdecs removes the line (not completely though, but almost)
 
1 - 10 of 10 Posts
Top