Next Generation Emulation banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've searched far and wide for an answer that would save me, but to no avail.

I have downloaded a save file for valkyrie profile, a .gme file.
Now it's said ePSXe can run those, but when I loaded it up into the memory card slot and ran the game, no data was found.
So I converted it to .mcr and .mcd as well, and once again no data was found.

I'm not quite sure what to do, as clearly I'm not getting any results from converting as many people suggest, so some hints would be lovely as to how I can get this problem fixed.
 

·
クロスエクス
Joined
·
4,890 Posts
Did you check if the savegame was from the same region of yours?
If it's not, the game won't find the save, but you can change it by editing the save on the memcard.
(which I have no clue how, but I remember it was mentioned around, just search)
 

·
クロスエクス
Joined
·
4,890 Posts
Maybe there's some step not being well done...

After you've converted it, when you emulate the BIOS, does the savegame shows on the memcard?

If so, then there's a mismatch with the versions of the game or something.
If not, then you're not configuring the emulator to load the correct memcard file.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top