Next Generation Emulation banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'm pretty sure a few of you might be annoyed at the fact that you have to actually use a disc or virtual drive to run a ROM in the ePSXeCutor, and now you have to switch your settings around every time you switch a ROM. :mad: I had the same problem and found a workaround for the problem.

To run a ROM image on ePSXeCutor:


1. Create a new configuration.
2. Set any old settings, do what you need to do for that config.
3. Now, finally, click on the 'Options' tab.
4. In the 'Command Line' box, type the following, the word ROM according to the ROM's entire directory name:

Code:
-loadiso "ROM" -nogui
For example,
Code:
-loadiso "C:\Users\Arch\ePSXe\ROMs\rom.iso" -nogui
would be a good code to put in that box.

5. Doubleclick your configuration's icon and it'll run! You're set to go!

Post any problems with my workaround here and I'll see if I can fix them.
:thumb:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top