Next Generation Emulation banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,471 Posts
No problems here.I've tried:
PCSX2-r1504 with:
GSdx-SSE2-r1650(DX9HW,Native and Logarithmic Z are on,everything else off)
ZeroSPU2(default settings),Lilypad-r1853(nothing special) and Gigaherz's CDVD(I tried the game from the disk).
For pcsx2 settings:
CPU - No speed limit(I can't get full speed anyway),everything else is on except microVU 0/1
Speed hacks - all on and max except Status Flag Hack and Min/Max Hack
Advanced - Default Settings

I also tried with pcsx2-r1888(the newest beta) but with SPU2-X(1.2.0)(recommended settings and nothing is checked) and GSdx-SSE2-r1873 and without any speed hack.No problems at all
 

·
Registered
Joined
·
2,471 Posts
You mean at that particular scene? because my FFX had been working fine for 6 hours, but always stopped dead at that one scene.
A lot of users complain about freezing/crashing after different scenes but I don't have any problems.I just downloaded a save on the first possible save spot after the sin battle and just played to see if pcsx2 will freze/crash after that scene but i didn't have any problems
Thanks for your help. I'll try with your config.
There is nothing special about my settings,I just started the game to see if the emu will encounter a problem after that scene,I didn't modify any settings especially good for FFX.

We're talking about recompilers here, right? You recompile VURec 0/1, but not microVU 0/1?
microVU 0/1 are not enabled,everything else is enabled.

btw I have the international version too
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top