Next Generation Emulation banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I poured over the forums looking for a detailed answer to this, and could not find it, so I apologize for making a new thread....

I also don't know if this would be considered advanced or basic, but -

How in the crap do I access the ePSXe command line? I know the code I need and everything, I just have no idea what I'm supposed to do with it.

Again, I'm aware I'm retarded, I only just got ePSXe about a month ago and am trying so hard to play Chrono Cross (I need to put in the -noauto code).

So, if someone could draw me a picture (so to speak), I'd be eternally grateful. And, if this is in the wrong place, do let me know.
 

·
God of Douchebagness™
Joined
·
15,294 Posts


make a shortuct to the executable, then right click it and select "properties". in the field labeled "target", go to the very end and type in whatever command you want to use.

the image above shows how i have mine set up. just subsitute the command switch i am using with one you want to use.

also notice that there is a single space between the last quotation mark and the command switch i want to use, so make sure you have that space there. if you want to use multiple command switches just make sure

there is a space between each one and there is an "-" in front of each one.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top