Next Generation Emulation banner
1 - 1 of 1 Posts

·
Registered
Joined
·
9,506 Posts
The most obvious thig to check first is if the drive is powering up (Clicking when switching it on). If so then the power is ok. After that as bobotns said check the cable. If its one of the new fancy Udma66/100 cable make sure that is plugged in the right way round (ie blue section to the mobo) otherwise it won't work or will be problematic. Then check that the jumpers are set correctly. Next unplug any other devices to see if these are causing conficts. Then try it on the other ide channel in case that one is faulty.

If all else fails swap the drives in the 2 machines over.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top